Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide - Manual (Page 170)

Publication 1757-IN510A-EN-P - October 2003
6-10 Additional Redundant Server Procedures
Configuring the Time Service
1 . To set up the time service on SERVERB, complete the steps in
Knowledge Builder at Server and Client Configuration Guide
⇒
Configuring and Monitoring Redundant Server System
⇒
Synchronizing Date and Time on the Servers.
2. Click Star t ⇒ Pr ograms ⇒ Pr ocessLogix Server ⇒ Start-Stop
Pr ocessLogix Ser ver to call up the ProcessLogix Server dialog
box.
Restarting ProcessLogix Services
1 . With the Full Mode version of the dialog box active, click the
System Running option.
2. Click Yes to confirm the action and wait for the Server to change
its state.
3. Close the ProcessLogix Server dialog box.
Confirming Data Link is Available
1 . On SERVERA, click Star t ⇒ Run.
2. Enter >cmd< and click OK to open the DOS window.
3. At the DOS prompt, enter >dual_status< and press <Enter>.
4. The unsynchronized SERVERA data should be similar to this:
5. Verify that the data link is available.