Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide - Manual (Page 81)

Publication 1757-IN510A-EN-P - October 2003
ProcessLogix Server Installation Procedures 3-19
Configuring RSLinx Drivers
for Ethernet Supervisory
Network
1 . Verify the settings of the Ethernet Network Interface card to be
used to communicate with the controller.
Navigate in Knowledge Builder to:
Ethernet Implementation Guide
⇒
Configuration
⇒
Setting Up
Drivers and IP Addresses for more information.
2. Configure the IP Address for each controller.
Navigate in Knowledge Builder to:
Ethernet Implementation Guide
⇒
Configuration
⇒
Setting Up
Drivers and IP Addresses
⇒
Configuring and setting IP address
for Ethernet module section for more information.
3. Configure RSLinx drivers.
A driver must be configured for each controller.
Navigate in Knowledge Builder to:
Ethernet Implementation Guide
⇒
Configuration
⇒
Setting up
Drivers and IP Addresses
⇒
Configuring additional RSLinx
drivers for more information.
4. If you are installing ProcessLogix software on a redundant
Server pair, return to the beginning of Configuring RSLinx
Drivers for Ethernet Supervisory Network on page 3-19 and
repeat for
SERVERB. Once all Servers have been updated,
return to the checklist that led you to this task.
IMPORTANT
If you are using ControlNet for your Supervisory
Network, skip this section.
Refer to Configuring RSLinx Drivers for ControlNet
Supervisory Network on page 3-16.