Rockwell Automation 1771-QDC PLASTIC MOLD.MODULE - Manual (Page 13)

Summary of Changes
Publication 1771-6.5.88 – July 1997
This manual is a revision of the November 1992 edition for module
upgrade to series C, revision E and series D, revision A.
It contains information on the following enhancements:
For this enhancement: Refer to: On page:
Pro-set 700 Software data table addresses
(same as Pro-Set 600 addresses)
chapter 1 throughout
time delay to avoid nuisance alarms MCC64 2-73
more accurate end-of-post-decompression position
(now includes shot size (PPC61) + cushion size (PPC62)
PSC05 2-93
adjust the stop point to an offset rather than 0V or 4mA
MCC05-08, and
MCC error codes 405-408 2-69
4-4
override loss-of-sensor protection MCC02-B08 thru B15 2-68
loss-of-sensor protection with indication by system status bits
SYS08-B00 thru B07
SYS12-B00 thru B07 3-33
3-35
added a tolerance with hysteresis of 0.05” (0.5mm) to mold
open and ejector retract positions indicated by their status bits SYS03-B07 for OPC62
SYS03-B15 for EPC60 3-27
3-28
detect and report double-command-bit error in DYC01,
and in DYC02 SYS23
SYS24
3-46
you can enter maximum travel limits as position setpoints chapter 4, error codes throughout
starting in Series D
added process trace to store traces of machine performance
(for Process Trace User Manual, see publication 6500-6.5.21)
configuration block PTC
status block PTS
command bits in DYC
status bits in SYS
PTC error codes 2-95 thru 2-96
3-22 thru 3-24
2-23 and 2-24
3-39, 40, 41, 42
4-57
single-transfer programming to report ejector status appendix A A-1
To help you find this new information, we added change bars as
shown to the right.
We have rearranged the format of this manual for quicker reference
and easier usage. The most prominent new feature is the order in
which we present command and status blocks. They are now in
alphabetical order.
New Information
New Format