Rockwell Automation 1771-QDC PLASTIC MOLD.MODULE - Manual (Page 34)

1–16 Abbreviated Command and Status Blocks
Publication 1771-6.5.88 – July 1997
Setpoints for Injection Profile (continued)
IPC36 N44:92 Segment 7 time
IPC37 N44:93 Segment 8 velocity
IPC38 N44:94 Segment 8 pressure
IPC39 N44:95 End of Segment 8 position
IPC40 N44:96 Segment 8 time
IPC41 N44:97 Segment 9 velocity
IPC42 N44:98 Segment 9 pressure
IPC43 N44:99 End of Segment 9 position
IPC44 N44:100 Segment 9 time
IPC45 N44:101 Segment 10 velocity
IPC46 N44:102 Segment 10 pressure
IPC47 N44:103 End of Segment 10 position
IPC48 N44:104 Segment 10 time
IPC49 N44:105 Segment 11 velocity
IPC50 N44:106 Segment 11 pressure
Profile Offsets
IPC51 N44:107 Velocity
IPC52 N44:108 Pressure
IPC53-56 N44:109-112 RFU
Pressure Limiting Values
IPC57 N44:113 Ram (Screw) pressure, LimVel/Pos profile
IPC58 N44:114 Ram (Screw) position to begin pressure limiting
IPC59 N44:115 Time delay for change in algorithm
Transition Values
IPC60 N44:116 Time
IPC61 N44:117 Ram (Screw) position
IPC62 N44:118 Ram (Screw) pressure
IPC63 N44:119 Cavity pressure
Transition Pressure Inhibit
IPC64 N44:120 Ram (Screw) position
Important: If using Pro-Set 600 and a QDC module configured for
Clamp/Eject mode, this data is found in alternate files B35 and N41.
Word Pro-Set Address Description
Bit-mapped Control Words
JGC01 B34:36 Block ID 00000000 00000010
JGC02-04 B34:37-39 RFU
Jog Alarm Setpoints
JGC05 N40:61 Screw jog RPM alarm
JGC06 N40:62 Ram jog pressure alarm
JGC07 N40:63 Clamp jog pressure alarm
JGC08 N40:64 Ejector jog pressure alarm
JGC – Jog
Configuration Block