Rockwell Automation 1771-QDC PLASTIC MOLD.MODULE - Manual (Page 291)

6–7 Calibration Instructions
Publication 1771-6.5.88 – July 1997
Important: Calibrate inputs before outputs. Follow this procedure for:
•
calibrating the QDC module’s inputs
•
verifying the calibration
For each calibration below, you will:
•
apply precise voltages using the input wiring arm
•
enter command codes in BTW word 2 with your programming
terminal
For each verification below, you will:
•
apply precise voltages using the input wiring arm
•
read verification codes in BTR words 10-13
1. To calibrate the 0 to +10V dc range:
Step Enter Command Code (BTW 2): With Applied Voltage and Read in BTR:
1 0000H 000.0 word 2 = 000F
2 8000H
3 0008H
4 8008H
5 0008H 10.000 word 3 = 000F
6 8008H
2. To verify 0 to +10V range, enter command codes 0100H and 8100H.
Then apply the following voltages:
Step Apply this Voltage and Read Verification Code (BTR 10-13):
1 000.0 000H
2 5.000 800H
3 9.997 FFFH
3. To calibrate the 1 to 5V dc range:
Step Enter Command Code (BTW 2): With Applied Voltage and Read in BTR
1 0010H 1.000 word 2 = 00FF
2 8010H
3 0010H 5.000 word 3 = 00FF
4 8010H
4. To verify 1 to 5V range, enter command codes 0400H and 8400H.
Then apply the following voltages:
Step Apply this Voltage and Read Verification Code (BTR 10-13):
1 1.000 000H
2 3.000 800H
3 5.000 FFFH
Calibration Procedure
for Inputs