Rockwell Automation 1771-QDC PLASTIC MOLD.MODULE - Manual (Page 191)

3–15 Status Word/Bit Descriptions
Publication 1771-6.5.88 – July 1997
IPS
Word Bit Description
B06 Segment 7
B07 Segment 8
B08 Segment 9
B09 Segment 10
B10 Segment 11
B11-B15 Open
IPS08 CV Low Limit Alarms
The module latches each bit when executing the subject profile segment in closed loop, and drives its algorithm CV to
minimum (0%) in an attempt to control the profile setpoint.
The module unlatches each bit when it completes execution of the subject profile segment in open loop, or in closed
loop without driving its algorithm CV to minimum (0%).
When this bit
is latched ON: algorithm CV
is maximum during:
B00 Segment 1
B01 Segment 2
B02 Segment 3
B03 Segment 4
B04 Segment 5
B05 Segment 6
B06 Segment 7
B07 Segment 8
B08 Segment 9
B09 Segment 10
B10 Segment 11
B11-B15 Open
Injection Profile Actuals
Word Description
IPS09 Actual Segment 1 Velocity [05] or [06] Average ram (screw) velocity during last Segment 1.
If IPC03-B14 is RESET, the module reports this average in percent velocity.
If IPC03-B14 is SET, it reports it in in.(mm)/s.
IPS10 Actual Segment 1 Pressure [01] Average ram (screw) pressure during last Segment 1.
IPS11 Actual Segment 1 Execution Time [21] Time required for last Segment 1.
IPS12 Actual End of Segment 1 Position [12] Ram (Screw) position at completion of last Segment 1.
IPS13 Actual Segment 2 Velocity [05] or [06] Average ram (screw) velocity during last Segment 2.
If IPC03-B14 is RESET, the module reports this average in percent velocity.
If IPC03-B14 is SET, it reports it in in.(mm)/s.
IPS14 Actual Segment 2 Pressure [01] Average ram (screw) pressure during last Segment 2.
IPS15 Actual Segment 2 Execution Time [21] Time required for last Segment 2.
IPS16 Actual End of Segment 2 Position [12] Ram (Screw) position at completion of last Segment 2.
IPS17 Actual Segment 3 Velocity [05] or [06] Average ram (screw) velocity during last Segment 3.
If IPC03-B14 is RESET, the module reports this average in percent velocity.
If IPC03-B14 is SET, it reports it in in.(mm)/s.
IPS18 Actual Segment 3 Pressure [01] Average ram (screw) pressure during last Segment 3.
IPS19 Actual Segment 3 Execution Time [21] Time required for last Segment 3.
IPS20 Actual End of Segment 3 Position [12] Ram (Screw) position at completion of last Segment 3.
IPS21 Actual Segment 4 Velocity [05] or [06] Average ram (screw) velocity during last Segment 4.
If IPC03-B14 is RESET, the module reports this average in percent velocity.
If IPC03-B14 is SET, it reports it in in.(mm)/s.
IPS22 Actual Segment 4 Pressure [01] Average ram (screw) pressure during last Segment 4.