H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 114)

16-4
Table 16-3 Configuration items of configuring ports for a mirroring group
Item Description
Mirroring Group ID
ID of the mirroring group to be configured
The available groups were created in advance.
Port Type
Sets the types of the ports to be configured:
Monitor Port: configures the monitor port for the mirroring group.
Mirror Port: configures mirroring ports for the mirroring group.
Stream Orientation
Set the direction of the traffic monitored by the monitor port of the mirroring group
This configuration item is available when Mirror Port is selected is the Port Type
drop-down list.
both: Mirrors both received and sent packets on mirroring ports.
inbound: Mirrors only packets received by mirroring port.
outbound: Mirrors only packets sent by mirroring ports.
interface name Select the ports to be configured from the interface name list.
Return to Port mirroring configuration task list .
Configuration Examples
Network requirements
As shown in Figure 16-4 , the customer network is as described below:
Packets from AP access AC through GigabitEthernet 1/0/1.
Server is connected to GigabitEthernet 1/0/2 of AC.
Configure port mirroring to monitor the bidirectional traffic on GigabitEthernet 1/0/1 of AC on the server.
To satisfy the above requirement through port mirroring, perform the following configuration on AC:
Configure GigabitEthernet 1/0/1 of AC as a mirroring port.
Configure GigabitEthernet 1/0/2 of AC as the monitor port.
Figure 16-4 Network diagram for port mirroring configuration
Configuration procedure
# Create a mirroring group.
Select Device > Port Mirroring from the navigation tree and click Create to enter the page shown
in Figure 16-5 .