H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 413)

36-17
Figure 36-13 Configure the RADIUS authentication server
Perform the following configurations as shown in Figure 36-13 .
Select Authentication Server as the server type.
Enter the primary server IP address 1.1.1.2.
Enter the primary server UDP port number 1812.
Select active as the primary server status.
Click Apply.
# Configure the RADIUS accounting server.
Figure 36-14 Configure the RADIUS accounting server
Perform the following configurations as shown in Figure 36-14 .
Select Accounting Server as the server type.
Enter the primary server IP address 1.1.1.2.
Enter the primary server UDP port number 1813.
Select active as the primary server status.
Click Apply to finish the operation.
# Configure the scheme used for communication between the device and the RADIUS servers as
follows:
Select the RADIUS Setup tab to enter the RADIUS parameter configuration page.