H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 505)

42-17
Click Enable.
3) Configure rogue detection rules.
Select Security > Rogue Detection from the navigation tree, and then select the Rule List tab to enter
the rule list configuration page. Then click Add.
Select MAC as the list type and type 000f-e215-1515, 000f-e215-1530, and 000f-e213-1235 in the
MAC address text box.
Select Attacker as the list type and type 000f-e220-405e in the text box.
Click Apply.
4) Enable countermeasures against the static rogue device.
Select Security > Rogue Detection from the navigation tree, and then select the AP Monitor tab. On
the page, click Common Set to enter the common configuration page, as shown in Figure 42-25 .
Figure 42-25 Countermeasures configuration
Select the Static Rogue Device check box. This is because the MAC address of Client 4 is added
manually to the attacker list.
Click Apply.
Configuration Guidelines
The radio must be disabled so that the AP operation mode can be changed.
If you configure more than one detection rule, you need to specify the rogue device types (AP,
client, bridge, and ad hoc) and the rule matching order. For detailed information, refer to section
" Configuring Detection Rules " on page 42-7 .
The wireless service configuration is needed for an AP operating in hybrid mode The wireless
service configuration is not needed for an AP in monitor mode.