H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 292)

31-38
Figure 31-49 Security setup
Select the Open-System from the Authentication Type drop-down list.
Select Cipher Suite check box, select CCMP and TKIP (select an encryption type as needed),
and then select WPA from the Security IE drop-down list.
Select the Port Set check box, and select psk from the Port Mode drop-down list.
Select pass-phrase from the Preshared Key drop-down list, and type key ID 12345678.
Click Apply.
# Enable wireless service.
Select Wireless Service > Access Service from the navigation tree to enter the page for enabling
wireless service, as shown in Figure 31-50 :
Figure 31-50 Enable wireless service
Select the psk[Bind] check box.
Click Enable.
3) Bind an AP radio to a wireless service
Select Wireless Service > Access Service from the navigation tree, and click Bind at the right side of
the wireless service psk to enter the page for binding an AP radio, as shown in Figure 31-51 :