H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 526)

45-14
Configuring a Rule for a Basic IPv6 ACL
Select QoS > ACL IPv6 from the navigation tree and then select the Basic Setup tab to enter the rule
configuration page for a basic IPv6 ACL, as shown in Figure 45-7 .
Figure 45-7 The page for configuring a rule for a basic IPv6 ACL
Table 45-13 describes the configuration items for creating a rule for a basic IPv6 ACL.
Table 45-13 Configuration items for a basic IPv6 ACL rule
Item Description
Select Access Control List
(ACL) Select the basic IPv6 ACL for which you want to configure rules.
Available ACLs are basic IPv6 ACLs that have been configured.
Rule ID
Select the Rule ID check box and type a number for the rule.
If you do not specify the rule number, the system will assign one automatically.
Operation
Select the operation to be performed for IPv6 packets matching the rule.
Permit: Allows matched packets to pass.
Deny: Drops matched packets.
Check Fragment
Select this check box to apply the rule to only non-first fragments.
If you do no select this check box, the rule applies to all fragments and
non-fragments.
Check Logging
Select this check box to keep a log of matched IPv6 packets.
A log entry contains the ACL rule number, operation for the matched packets,
protocol that IP carries, source/destination address, source/destination port
number, and number of matched packets.