H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 129)

18-9
Table 18-5 Configuration items for configuring an SNMP community
Item Description
Community Name Set the SNMP community name.
Access Right
Configure SNMP NMS access right
Read only: The NMS can perform read-only operations to the MIB objects when it
uses this community name to access the agent,
Read and write: The NMS can perform both read and write operations to the MIB
objects when it uses this community name to access the agent.
View
Specify the view associated with the community to limit the MIB objects that can be
accessed by the NMS.
ACL
Associate the community with a basic ACL to allow or prohibit the access to the agent
from the NMS with the specified source IP address.
Return to SNMPv1 or SNMPv2c configuration task list .
Configuring an SNMP Group
Select Device > SNMP from the navigation tree, then click the Group tab to enter the page as shown in
Figure 18-11 . Click Add to enter the Add SNMP Group page as shown in Figure 18-12 .
Figure 18-11 SNMP group
Figure 18-12 Create an SNMP group
Table 18-6 describes the configuration items for creating an SNMP group.