H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 525)

45-13
Item Description
LSAP Type
LSAP Mask
Select the LSAP Type check box and specify the DSAP and SSAP
fields in the LLC encapsulation by configuring the following two items:
LSAP Type: Indicates the frame encapsulation format.
LSAP Mask: Indicates the LSAP wildcard.
Protocol Type
Type Filter
Protocol Mask
Select the Protocol Type check box and specify the link layer protocol
type by configuring the following two items:
Protocol Type: Indicates the frame type. It corresponds to the
type-code field of Ethernet_II and Ethernet_SNAP frames.
Protocol Mask: Indicates the wildcard.
Time Range
Select the time range during which the rule takes effect.
Available time ranges are those that have been configured.
Return to IPv4 ACL configuration task list .
Creating an IPv6 ACL
Select QoS > ACL IPv6 from the navigation tree and then select the Create tab to enter the IPv6 ACL
configuration page, as shown in Figure 45-6 .
Figure 45-6 The page for creating an IPv6 ACL
Table 45-12 describes the configuration items for creating an IPv6 ACL.
Table 45-12 IPv6 ACL configuration items
Item Description
ACL Number Type a number for the IPv6 ACL.
Match Order
Select a match order for the ACL. Available values are:
Config: Packets are compared against ACL rules in the order the rules are
configured.
Auto: Packets are compared against ACL rules in the depth-first match order.
Return to IPv6 ACL configuration task list .