H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 506)

43-1
43
Authorized IP
The sample output in this manual was created on the WX5004. The output on your device may
vary.
The grayed out functions or parameters on the Web interface indicate that they are not supported
or cannot be modified.
The models listed in this manual are not applicable to all regions. Please consult your local sales
office for the models applicable to your region.
Overview
The authorized IP function is to associate the HTTP or Telnet service with an ACL to filter the requests of
clients. Only clients that pass the ACL filtering can access the device.
Configuring Authorized IP
Before configuring authorized IP, you need to create and configure the ACL. For ACL configuration,
refer to QoS Configuration.
Select Security > Authorized IP from the navigation tree at the left side of the interface, and then
select the Setup tab to enter the authorized IP configuration page, as shown in Figure 43-1 .