H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 363)

34-8
Figure 34-7 Lock a channel
Select the check box of the target radio, and click Lock Channel.
Note that:
Channel locking takes effect only when the AC adopts the auto mode. For more information about
automatic channel adjustment, see Configuring Radio Parameters .
If you enable channel locking and then enable the radio, the AC automatically selects an optimal
channel, and then locks the channel.
When the AC detects any radar signals, it immediately selects another channel even if the current
channel is locked, and then locks the new channel.
If you lock the current channel first, and then enable channel adjustment, channel adjustment does
not work because the current channel is locked. Therefore, before enabling channel adjustement,
make sure that the current channel is not locked. If you enable channel adjustment and then lock
the current channel, the last selected channel is locked. For information about channel adjustment,
see Channel Adjustment . For how to configure channel adjustment, see Parameter Settings .
Locking the Power
Select Radio > Radio from the navigation tree to enter the page as shown in Figure 34-8 .
Figure 34-8 Lock the current power
Select the check box of the target radio, and click Lock Power.
Note that:
For transmission power configuration, see Configuring Radio Parameters .