Yaskawa iQpump Micro - Manual (Page 82)

3.9 Wiring Checklist
No. Item Page
Drive, peripherals, option cards
1 Check drive model number to ensure receipt of correct model. 46
2 Check for correct braking resistors, DC link chokes, noise filters, and other peripheral devices. –
Installation area and physical setup
3 Ensure area surrounding the drive complies with specifications. 50
Power supply voltage, output voltage
4 The voltage from the power supply should fall within the input voltage specification range of the drive. –
5 The voltage rating for the motor should match the drive output specifications. 46
Main circuit wiring
6 Confirm proper branch circuit protection exists per National and Local codes. 60
7 Properly wire the power supply to drive terminals R/L1, S/L2 and T/L3. –
8
Properly wire the drive and motor together.
The motor lines and drive output terminals R/T1, V/T2 and W/T3 should match in order to produce the desired
phase order. If the phase order is incorrect, the drive will rotate in the opposite direction.
73
9 Use 600 Vac vinyl-sheathed wire for the power supply and motor lines. 70
10
Use the correct wire gauges for the main circuit. Refer to Table 3.4 , Table 3.5 , or Table 3.6 . 70
When using comparatively long motor cable, calculate the amount of voltage drop.
3 x voltage resistance (Ω/km) x cable length (m) x motor rated current (A) x 10 -3
Motor rated voltage (V) x 0.02 ≥
70
If the cable between the drive and motor exceeds 50 m, adjust the carrier frequency (C6-02) accordingly. 73
11 Properly ground the drive. 73
12 Tightly fasten all terminal screws. Refer to Table 3.4 , Table 3.5 , or Table 3.6 . 70
13
Set up overload protection circuits when running multiple motors from a single drive.
M1
OL1
OL2
OLn
MC1
MC2
MCn
M2
Mn
Drive
MC1 - MCn
OL 1 - OL n ... magnetic contactor
... thermal relay
Power supply
Note: Close MC1 through MCn before operating the drive.
–
14
If using a braking resistor or dynamic braking resistor unit, install a magnetic contactor. Properly install the resistor,
and ensure that overload protection shuts off the power supply.
–
15 Verify phase advancing capacitors are NOT installed on the output side of the drive. –
Control circuit wiring
16 Use twisted-pair cables for all drive control circuit wiring. –
17 Ground the shields of shielded wiring to the GND terminal. 77
18 If using a 3-Wire sequence, set parameters for MFDI terminals S1 through S7, and properly wire control circuits. 62
19 Check for any other wiring mistakes. Only use a multimeter to check wiring. –
20 Properly fasten the control circuit terminal screws in the drive. Refer to Table 3.4 , Table 3.5 , or Table 3.6 . 70
21 Pick up all wire clippings. –
22 Ensure that no frayed wires on the terminal block are touching other terminals or connections. –
23 Properly separate control circuit wiring and main circuit wiring. –
24 Analog signal line wiring should not exceed 50 m. –
25 Safe Disable Input wiring should not exceed 30 m. –
3.9 Wiring Checklist
82 YASKAWA TOEP YAIQPM 03B YASKAWA AC Drive - iQpump Micro User Manual