Yaskawa iQpump Micro - Manual (Page 93)

u LCD Display
Figure 4.6 LCD Display
Table 4.3 Display and Contents
No. Name Display Content
1 Operation Mode Menus
MODE Displayed when in Mode Selection.
QMONI: Use F1/F2 Instructions to access the Quick Monitors.
MENU: Use UP/
DWN
Instructions to access the next menu item.
MONITR Displayed when in Monitor Mode.
VERIFY Indicates the Verify Menu.
PRMSET Displayed when in Parameter Setting Mode.
A.TUNE Displayed during Auto-Tuning.
SETUP Displayed when in Setup Mode.
2 Mode Display Area
DRV Displayed when in Drive Mode.
PRG Displayed when in Programming Mode.
3 Ready Rdy Indicates the drive is ready to run.
4 Data Display — Displays specific data and operation data.
5
Frequency
Reference
Assignment <1>
OPR Displayed when the frequency reference is assigned to the HOA keypad.
COM
Displayed when the frequency reference is assigned to the MEMOBUS/Modbus
Communication Inputs of the drive.
OP Displayed when the frequency reference is assigned to option card connected to the drive.
AI Displayed when the function reference is assigned to an analog input.
OFF Displayed when HAND mode is OFF.
6
LOCAL/REMOTE
Display <2>
RSEQ Blinks when the Run command is supplied from a remote source.
LSEQ Displayed when the Run command is supplied from the HOA keypad.
RREF Blinks when the Run command is supplied from a remote source.
LREF Displayed when the Run command is supplied from the HOA keypad.
7
Function Key 2
(F2)
<-MONITOR->
Pressing F2 displays the next Quick Monitor.
DATA
Pressing F2 scrolls to the next display.
→
Pressing F2 scrolls the cursor to the right.
RESET
Pressing F2 resets the existing drive fault error.
Monitor
Pressing F2 switches Monitor mode.
8 FWD/REV
FWD Indicates forward motor operation.
REV Indicates reverse motor operation.
4.5 Using the Optional HOA Keypad
YASKAWA TOEP YAIQPM 03B YASKAWA AC Drive - iQpump Micro User Manual 93
4
Start-Up Programming & Operation