Yaskawa Yasnac PC NC - Manual (Page 110)

YASNAC PC NC Operating Manual Chapter 3: HMI Process Operation
3 - 58
Traversing the tool offsets table:
• Touch the one of the cells in the tool offset table. This will cause the cell to be outlined in
black.
• Try pressing some of the arrow keys on the keyboard to move around in the table. The black
outline will jump to the next selected cell. If that cell is in the Length column, the text on the
Set button will also change to reflect which offset is selected.
• The PgDn key is used to move to the next page of offsets. The PgUp key will go to the previ-
ous page. The up and down arrows to the right of the grid can also be used to change pages.
3.5.2 Magazine Screen
Fig. 3.5.2.1 The Tool Magazine Screen
The Tools:Magazine screen, shown in Figure 3.5.2.1 on page 58, displays the current associations
between tool pots and tool numbers. Tool numbers can be either 2 or 4 digits, based on parameter
settings. Tool pot data is stored in keep memory, and these keep memory addresses are also set
using parameters.
If the tool pots table is too large to fit on one screen, the arrow up and down keys will
appear and can be used to scroll to previous and subsequent pages of tool pot data.
It is possible to search for a particular tool pot on the screen. To do this, type a number into the
Jump to Tool Pot field and press Enter. The tool value corresponding to the matching tool pot
will be highlighted.