Yaskawa Yasnac PC NC - Manual (Page 217)

YASNAC PC NC Operating Manual Appendix 2: Alarm Tables
A2 - 13
alarm.3063 Overload (3rd-axis)
alarm.3064 Overload (4th-axis)
alarm.3065 Overload (5th-axis)
alarm.3081 Disconnection in PG wiring (1st-axis)
alarm.3082 Disconnection in PG wiring (2nd-axis)
alarm.3083 Disconnection in PG wiring (3rd-axis)
alarm.3084 Disconnection in PG wiring (4th-axis)
alarm.3085 Disconnection in PG wiring (5th-axis)
alarm.3091 Disconnection in PG wiring (spindle)
alarm.3100 YENET1200 drive error has been detected.
alarm.3101 Servo pack error has occurred (1st-axis).
alarm.3102 Servo pack error has occurred (2nd-axis).
alarm.3103 Servo pack error has occurred (3rd-axis).
alarm.3104 Servo pack error has occurred (4th-axis).
alarm.3105 Servo pack error has occurred (5th-axis).
alarm.3111 Servo pack communication error has occurred (1st-axis).
alarm.3112 Servo pack communication error has occurred (2nd-axis).
alarm.3113 Servo pack communication error has occurred (3rd-axis).
alarm.3114 Servo pack communication error has occurred (4th-axis).
alarm.3115 Servo pack communication error has occurred (5th-axis).
alarm.3121 Over-speed has been detected (1st-axis).
alarm.3122 Over-speed has been detected (2nd-axis).
alarm.3123 Over-speed has been detected (3rd-axis).
alarm.3124 Over-speed has been detected (4th-axis).
alarm.3125 Over-speed has been detected (5th-axis).
alarm.3131 Serial communication error has occurred in the communication with the inverter (spindle).
alarm.3141 Runaway is detected with the servo controlled axis (1st-axis).
alarm.3142 Runaway is detected with the servo controlled axis (2nd-axis).
alarm.3143 Runaway is detected with the servo controlled axis (3rd-axis).
alarm.3144 Runaway is detected with the servo controlled axis (4th-axis).
alarm.3145 Runaway is detected with the servo controlled axis (5th-axis).
alarm.3151 Phase detection error has occurred (1st-axis).
alarm.3152 Phase detection error has occurred (2nd-axis).
Alarm No. Description