Yaskawa Yasnac PC NC - Manual (Page 347)

YASNAC PC NC Operating Manual APPENDIX 3: Parameter Tables
A3 - 121
1512 No. of teeth of gear A on the motor interme-
diate tooth 0 32767 No. of teeth of the motor inter-
mediate gear A used for spin-
dle loop control.
If there is no intermediate
gear, set 0
1513 No. of teeth of gear A on the motor side
intermediate tooth 0 32767 No. of teeth on the motor side
of gear A used for spindle loop
control.
If there is no intermediate
gear, set 0.
1514 No. of teeth of gear B on the spindle side tooth 0 32767 No. of teeth of gear B on the
spindle side for spindle loop
control.
1515 No. of teeth of gear B on the spindle interme-
diate tooth 0 32767 No. of teeth of the spindle
intermediate gear B used for
spindle loop control.
If there is no intermediate
gear, set 0.
1516 No. of teeth of gear B on the motor interme-
diate tooth 0 32767 No. of teeth of the motor inter-
mediate gear B used for spin-
dle loop control
If there is no intermediate
gear, set 0
1517 No. of teeth of gear B on the motor side
intermediate tooth 0 32767 No. of teeth on the motor side
of gear B used for spindle loop
control.
If there is no intermediate
gear, set 0.
2000 1 Dry run during thread cutting 0 1
2831 1st axis bias in thread cutting accel/decel mm/min,
deg/min
0 240000
2832 2nd axis bias in thread cutting accel/decel mm/min,
deg/min
0 240000
2833 3rd axis bias in thread cutting accel/decel mm/min,
deg/min
0 240000
2834 4th axis bias in thread cutting accel/decel mm/min,
deg/min
0 240000
2835 5th axis bias in thread cutting accel/decel mm/min,
deg/min
0 240000
4015 5 G00 error detection during solid tap 0 1
6 Display peak value of synchronization error
in solid tap 0 1
Address Bit Description
Register
Units
Minimum
Value
Maximum
Value
Long Description