Yaskawa Yasnac PC NC - Manual (Page 121)

YASNAC PC NC Operating Manual Chapter 3: HMI Process Operation
3 - 69
The NC Configuration tab of the Configuration screen, shown in Figure 3.7.4.1 on page 68, is
provided for maintenance purposes and is not used for daily operation. This screen displays such
non-editable information as system numbers and software versions. The Boot Up .BMP file is
editable, and can be set by clicking the Change Bitmap button. This button is only enabled
for users with access levels of MTB or higher.
Fig. 3.7.4.2 Configuration Screen - Drive Configuration
The Drive Configuration tab of the Maintenance: Configuration screen, shown in Figure 3.7.4.2
on page 69, displays the types of servo packs and servo motors installed on the NC. This informa-
tion is for display purposes only and is not editable.
Setting the YENET station numbers:
• Go to the Drive Configuration tab of the Maintenance: Configuration screen to observe the
current YENET station numbers. They will be something like “2”, “3” and “4”.
• Switch to the Utilities: Login screen and log in as Machinist (or higher).
• Change to the Maintenance: Parameter Search screen and check the Search checkbox in the
top left corner of the screen. Set the search kind to Label, then type in “station number” and
hit Enter. This should display all the YENET station number parameters.
• Change the station numbers for the 1st, 2nd and 3rd axes (pm 1020 -1022) by selecting new
values in the drop-down menus.
• Press reset, then shut down and boot up the PC NC.
• Go to the Drive Configuration tab of the Maintenance: Configuration screen to see the
changed station numbers.