Yaskawa Yasnac PC NC User Manual
Page 211
YASNAC PC NC Operating Manual
Appendix 2: Alarm Tables
A2 - 7
alarm.397
During tape/direct operation, operation interruption that does not allow the re-execution has been carried out.
alarm.400
An O number of five or more digits is designated.
alarm.401
An N number of five or more digits is designated.
alarm.402
A P number of five or more digits is designated.
alarm.406
Before the axis move, the axis is in the stored stroke limit No. 2 area.
alarm.407
Before the axis move, the axis is in the stored stroke limit No. 3 area.
alarm.408
Before the axis move, the axis is in the stored stroke limit No. 4 area.
alarm.409
Before the axis move, the axis is in the stored stroke limit No. 5 area.
alarm.411
Reference point return has not been completed (X-axis).
alarm.412
Reference point return has not been completed (Y-axis).
alarm.413
Reference point return has not been completed (Z-axis).
alarm.414
Reference point return has not been completed (4th-axis).
alarm.415
Reference point return has not been completed (5th-axis).
alarm.421
After the execution of G27, the axis has not returned to the reference point (X-axis).
alarm.422
After the execution of G27, the axis has not returned to the reference point (Y-axis).
alarm.423
After the execution of G27, the axis has not returned to the reference point (Z-axis).
alarm.424
After the execution of G27, the axis has not returned to the reference point (4th-axis).
alarm.425
After the execution of G27, the axis has not returned to the reference point (5th-axis).
alarm.431
Before the axis move, the axis has reached the entry prohibited area (outside) of stored stroke limit (X-axis)
alarm.432
Before the axis move, the axis has reached the entry prohibited area (outside) of stored stroke limit (Y-axis)
alarm.433
Before the axis move, the axis has reached the entry prohibited area (outside) of stored stroke limit (Z-axis)
alarm.434
Before the axis move, the axis has reached the entry prohibited area (outside) of stored stroke limit (4th-axis)
alarm.435
Before the axis move, the axis has reached the entry prohibited area (outside) of stored stroke limit (5th-axis)
alarm.480
The cylindrical interpolation command error has occurred.
alarm.481
A command error has occurred in the cylindrical interpolation mode.
alarm.482
The polar coordinate interpolation command error has occurred.
alarm.483
A command error has occurred in the polar coordinate interpolation mode.
alarm.484
Program interrupt has occurred in the cylindrical or polar coordinate interpolation mode.
alarm.491
In the G31 block, skip signal (1) has not been input.
alarm.492
In the G31 block, skip signal (2) has not been input.
alarm.494
When G31 is executed, the skip signal (1) is not ready.
alarm.495
When G31 is executed, the skip signal (2) is not ready.
alarm.1000
DNC time-out error has occurred.
Alarm No.
Description