Hitachi L300P - Manual (Page 129)

Programming Error Codes
Configur
ing Dr
iv
e
P
a
ra
meters
3–60
Programming Error Codes
The L300P inverter operator keypad displays a special code (begins with the character) to
indicate a programming error. Programming errors exist when one parameter conflicts with the
meaningful range permitted by related parameter(s). Note that particular real-time frequency
(speed) input levels can cause a conflict in some situations. After a conflict exists, the error
code will appear on the display, or you can view it later with D090 in Monitor Mode. Also, the
PGM LED on the display will flash ON/OFF when programming. These indications are
automatically cleared when the parameter is corrected to the allowed range.
Programming Error
Code
Parameter out of bounds Boundary defined by...
Code Description <, > Code Description
001 201
A061 / A261 Frequency upper limit
setting; 1st, 2nd motor > A004 /
A204
Maximum frequency;
1st, 2nd motor
002 202
A062 / A262 Frequency lower limit
setting; 1st, 2nd motor >
004 204
A003 / A203 Base frequency setting;
1st, 2nd motor >
005 205
F001,
A020 / A220 Output frequency setting,
Multi-speed freq. setting;
1st, 2nd motor >
006 206
A021 to A035 Multi-speed freq. settings >
012 212
A062 / A262 Frequency lower limit
setting; 1st, 2nd motor > A061 / A261 Frequency upper limit setting;
1st, 2nd motor
015 215
F001,
A020 / A220 Output frequency setting,
Multi-speed freq. setting;
1st, 2nd motor >
016 216
A021 to A035 Multi-speed freq. settings >
021 221
A061 / A261 Frequency upper limit
setting; 1st, 2nd motor < A062 / A262 Frequency lower limit setting;
1st, 2nd motor
025 225
F001,
A020 / A220 Output frequency setting,
Multi-speed freq. setting;
1st, 2nd motor <
031 231
A061 / A261 Frequency upper limit
setting; 1st, 2nd motor < B082 Start frequency adjustment
032 232
A062 / A262 Frequency lower limit
setting; 1st, 2nd motor <
035 235
F001,
A020 / A220 Output frequency setting,
Multi-speed freq. setting;
1st, 2nd motor <
036
A021 to A035 Multi-speed freq. settings <
037
A038 Jog frequency setting <
085 285
F001,
A020 / A220 Output frequency setting,
Multi-speed freq. setting;
1st, 2nd motor >f-x,
<f+x A063 ± A064
A065 ± A066
A067 ± A068 Jump (center) frequency ±
jump (hysteresis) frequency
width setting
(See note after table)
086
A021 to A035 Multi-speed freq. settings >f-x,
<f+x