Hitachi L300P - Manual (Page 77)

“F” Group: Main Profile Parameters
Configur
ing Dr
iv
e
P
a
ra
meters
3–8
“F” Group: Main Profile Parameters
The basic frequency (speed) profile is
defined by parameters contained in the
“F” Group as shown to the right. The
output frequency is set in Hz, but accel-
eration and deceleration are specified
seconds (the time to ramp from zero to
maximum frequency, or from maximum
frequency to zero). The motor direction
parameter determines whether the
keypad Run key produces a FW or RV
command. This parameter does not
affect the [FW] terminal or [RV] intelligent terminal function, which you configure separately.
Acceleration 1 and Deceleration 1 are the standard default accel and decel values for the main
profile. Accel and decel values for an alternative profile are specified by using parameters Ax92
through Ax93. The motor direction selection (F004) determines the direction of rotation as
commanded only from the keypad. This setting applies to either motor profile (1st or 2nd) in
use at a particular time.
Output
frequency
F001
F002 F003
t
“F” Function Run
Mode
Edit
Lo Hi
Defaults
Units SRW Display
Func.
Code
Name Description
–FE2
(CE)
–FU2
(UL)
–FR
(Jpn)
F001 Output frequency
setting Standard default target
frequency that determines
constant motor speed
Range is 0 to 360 Hz ✔ ✔ 0.00 0.00 0.00 Hz >F001 SET-Freq.
TM 0000.00Hz
2FS 0000.00Hz
3FS 0000.00Hz
TM 0000.00Hz
JG 0000.00Hz
1S 0000.00Hz
15S 0000.00Hz
OP1 0000.00Hz
OP2 0000.00Hz
RS485 0000.00Hz
F002 Acceleration (1) time
setting Standard default accelera-
tion
Range is 0.01 to 3600 sec. ✔ ✔ 30.0 60.0 30.0 sec. >F002 ACCEL
TIME1 0030.00s
F202 Acceleration (1) time
setting, 2nd motor Standard default accelera-
tion, 2nd motor
Range is 0.01 to 3600 sec.
✔ ✔ 30.0 60.0 30.0
sec. >F202 2ACCEL
TIME1 0030.00s
F003 Deceleration (1) time
setting Standard default decelera-
tion
Range is 0.01 to 3600 sec.
✔ ✔ 30.0 60.0 30.0
sec. >F003 DECEL
TIME1 0030.00s
F203 Deceleration (1) time
setting, 2nd motor Standard default decelera-
tion, 2nd motor
Range is 0.01 to 3600 sec.
✔ ✔ 30.0 60.0 30.0
sec. >F203 2DECEL
TIME1 0030.00s
F004 Keypad Run key routing Two options; select codes:
00 Forward
01 Reverse
✘ ✘
00 00 00 — >F004 DIG-RUN
SELECT FW