Hitachi L300P - Manual (Page 157)

L300P Inverter
Oper
ati
ons
and Monitor
ing
4–27
Thermistor
Thermal
Protection Motors that are equipped with a thermistor can be protected from overheating. Input terminal
[TH] is dedicated to sense a thermistor resistance. The input can be set up (via B098 and B099)
to accept a wide variety of NTC or PTC type thermistors. Use this function to protect the motor
from overheating.
Opt.
Code
Symbol Function Name
Input
State
Description
— TH Thermistor Thermal
Protection Sensor When a thermistor is connected between
to terminals [TH] and [CM1], the inverter
checks for over-temperature and will
cause a trip (E35) and turn OFF the output
to the motor
Open An open circuit in the thermistor causes a
trip, and the inverter turns OFF the output
Valid for
inputs: [TH] only
Required
settings: B098 and B099
Notes:
• Be sure the thermistor is connected to termi-
nals [TH] and [CM1]. If the resistance is
above or below (depending on whether NTC
or PTC) the threshold the inverter will trip.
When the motor cools down enough, the
thermistor resistance will change enough to
permit you to clear the error. Press the STOP/
Reset key to clear the error.
5 3 1 4 2 FW TH
PLC P24 CM1
Example:
MOTOR
thermistor
See I/O specs on page 4–8 .
TH