3Com WXR100 3CRWXR10095A - Manual (Page 103)

set banner acknowledge 103
„
message — Up to 32 alphanumeric characters, but not the delimiting
character.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 6.0.
Usage Enable the MOTD prompt, then optionally specify a prompt
message.
When a user logs into the WX switch using the CLI, the configured MOTD
banner is displayed, followed by the MOTD prompt message (if one is
specified). In response, the user has the option of entering y to proceed
or any other key to
terminate the connection.
Examples — To enable the prompt for the MOTD banner, type the
following command:
WX# set banner acknowledge enable
success: change accepted.
To set Do you agree? as the text to be displayed following the MOTD
banner, type
the following command:
WX# set banner acknowledge message “Do you agree?”
success: change accepted.
After these commands are entered, when the user logs on, the MOTD
banner is
displayed, followed by the text Do you agree? If the user
enters y, then the login proceeds; if not, then the user is disconnected.
See Also
„
set banner motd on page 104
„
clear banner motd on page 90
„
display banner motd on page 93