3Com WXR100 3CRWXR10095A - Manual (Page 34)

34 N EW F EATURES S UMMARY
Simultaneous Login
Support You can now limit the number of concurrent sessions that a user can have
on the network. You can use the vendor-specific attribute (VSA) on a
RADIUS server or configure it as part of a service profile. You can apply
the attribute to users and user groups.
The attribute,
simultaneous-logins,
has been added to the following
commands:
set user username attr simultaneous-logins value
set usergroup group-name attr simultaneous-logins value
set service-profile name attr simultaneous-logins value
where value is between 0-1000. In the case of the set user attr
command, if you set the value to 0, then the user is locked out of the
network. The default value is unlimited access. In addition, setting this
value applies only to user sessions in the mobility domain and not a
specific WX.
To clear the configuration, use one of the following commands:
clear user username attr simultaneous-logins
clear usergroup group-name attr simultaneous-logins
Dynamic RADIUS
Extensions These commands and attributes support configuration of dynamic
RADIUS extensions per RFC 3576 (Dynamic Authorization Server MIB).
set radius dac Configures dynamic RADIUS extensions in support of RFC 3576.
Syntax — set radius dac name ip-addr key string [disconnect
[enable | disable] | [change-of-author [enable | disable] |
replay-protection [enable | disable] | replay-window seconds]
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 6.2.
set radius das-port Configures the dynamic authorization port for dynamic RADIUS servers.
Syntax —
set radius das-port port_number
Defaults — None.