3Com WXR100 3CRWXR10095A - Manual (Page 451)

set radio-profile auto-tune channel-holddown 451
Examples — The following command disables dynamic channel tuning
for radios in the rp2 radio profile:
WX4400# set radio-profile rp2 auto-tune channel-config
disable
success: change accepted.
See Also
„
display radio-profile on page 398
„
set ap radio channel on page 435
„
set radio-profile auto-tune channel-holddown on page 451
„
set radio-profile auto-tune channel-interval on page 452
„
set radio-profile auto-tune power-config on page 454
set radio-profile
auto-tune
channel-holddown Sets the minimum number of seconds a radio in a radio profile must
remain at its current channel assignment before RF Auto-Tuning can
change the channel. The channel holddown provides additional stability
to the network by preventing the radio from changing channels too
rapidly in response to spurious RF anomalies such as short-duration
channel interference.
Syntax — set radio-profile name auto-tune channel-holddown
holddown
„ name — Radio profile name.
„ holddown
— Minimum number of seconds a radio must remain on its
current channel setting before RF Auto-Tuning is allowed to change
the channel. You can specify from 0 to 65535 seconds.
Defaults — The default RF Auto-Tuning channel holddown is 900
seconds.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — The channel holddown applies even if RF anomalies occur that
normally cause an immediate channel change.