3Com WXR100 3CRWXR10095A - Manual (Page 416)

416 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
Examples — The following command changes the bias for a Distributed
MAP to low:
WX4400# set dap 1 bias low
success: change accepted.
See Also
„
display ap config on page 364
set ap blink Enables or disables LED blink mode on a MAP to make it easy to identify.
When blink mode is enabled on (MAP-xxx models, the health and radio
LEDs alternately blink green and amber. By default, blink mode is
disabled.
Syntax —
set {ap ap-number auto blink {enable | disable}
„ ap ap-number
— Index value that identifies the MAP on the WX.
„ enable — Enables blink mode.
„ disable — Disables blink mode.
Defaults — LED blink mode is disabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0. Option auto added for
configuration of the MAP configuration profile. Version 6.0 removed the
dap option.
Usage — Changing the LED blink mode does not alter operation of the
MAP access point. Only the behavior of the LEDs is affected.
Examples — The following command enables LED blink mode on the
MAP access points connected to ports 3 and 4:
WX1200# set ap 3-4 blink enable
success: change accepted.