3Com WXR100 3CRWXR10095A - Manual (Page 380)

380 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
Examples — The following command displays the status of a MAP
access point:
WX4400# display ap status 7
Dap: 1, IP-addr: 10.2.34.56 (vlan 'vlan-corp'), MAP model: AP2750,
manufacturer: 3Com, name: DAP01
fingerprint: b4 : f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
====================================================
State: operational
CPU info: IBM:PPC speed=266666664 Hz version=405GPr
id=0x28f10158a47f0408 ram=33554432
s/n=0332600444 hw_rev=A3
Uptime: 21 hours, 27 minutes, 51 seconds
Radio 1 type: 802.11g, state: configure succeed [Enabled]
operational channel: 64 operational power: 14
base mac: 00:0b:0e:00:d2:c1
bssid1: 00:0b:0e:00:d2:94, ssid: private
The following command displays the status of a directly connected MAP:
WX# display ap status 7
AP: 7, AP model: AP3750, manufacturer 3Com, name: MP07
====================================================
State: operational (not encrypt)
CPU info: IBM:PPC speed=266666664 Hz version=405GPr, ram=33554432
s/n=0333703050 hw_rev=A3
Uptime: 503 hours, 51 minutes, 5 seconds
Radio 1 type: 802.11g, state: configure succeed [Enabled]
operational channel: 11 (Auto) operational power: 1
bssid1: 00:0b:0e:00:ca:c0, ssid: public
bssid2: 00:0b:0e:00:ca:c2, ssid: employee-net
load balance: enabled, current load: (unavailable)
RFID Reports: Inactive
Radio 2 type: 802.11a, state: configure succeed [Disabled] (Sweep mode)
operational channel: 44 (Auto) operational power: 1
bssid1: 00:0b:0e:00:ca:c1, ssid: mycorp-tkip
load balance: enabled, current load: (unavailable)
RFID Reports: Inactive