3Com WXR100 3CRWXR10095A - Manual (Page 252)

252 C HAPTER 7: IP S ERVICES C OMMANDS
Examples — The following commands configure an IP interface on
VLAN taupe and configure the interface to be the system IP address:
WX4400# set interface taupe ip 10.10.20.20/24
success: set ip address 10.10.20.20 netmask 255.255.255.0 on vlan taupe
WX4400# set system ip-address 10.10.20.20
success: change accepted.
See Also
„
clear system ip-address on page 194
„
display system on page 95
„
set interface on page 218
set timedate Sets the time of day and date on the WX.
Syntax —
set timedate {date mmm dd yyyy [time hh:mm:ss]}
„ date mmm dd yyyy
— System date:
„ mmm — month
„ dd — day
„ yyyy
— year
„ time hh:mm:ss — System time, in hours, minutes, and seconds.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — The day of week is automatically calculated from the day that
you set. The time displayed by the CLI after you type the command might
be slightly later than the time you enter due to the interval between when
you press Enter and when the CLI reads and displays the new time and
date.
Configure summertime before you set the time and date. Otherwise, the
summertime adjustment makes the time incorrect, if the date is within
the summertime period.