3Com WXR100 3CRWXR10095A - Manual (Page 753)

set snoop mode 753
set snoop mode Enables a snoop filter. A snoop filter does not take effect until you map it
to a MAP radio and enable the filter.
Syntax — set snoop { filter-name | all}
mode {enable [stop-after num-pkts] | disable}
„ filter-name | all — Name of the snoop filter. Specify all to enable
all snoop filters.
„ enable — Enables the snoop filter.
„ disable — Disables the snoop filter.
Defaults — Snoop filters are disabled by default.
Access — Enabled.
History —Introduced in MSS Version 4.0. Version 6.0 removed the
stop-after option. Also filter mode was made persistent across restarts.
Usage — The filter mode is retained even if you disable and reenable the
radio, or restart the MAP or the WX switch. Once the filter is enabled,
you must use the disable option to disable it.
Examples — The following command enables snoop filter snoop1:
WX# set snoop snoop1 mode enable
success: filter 'snoop1' enabled
See Also
„
display snoop on page 754
„
display snoop info on page 754
„
display snoop map on page 755
„
display snoop stats on page 756