3Com WXR100 3CRWXR10095A - Manual (Page 577)

set igmp oqi 577
Usage — You cannot add MAP access ports or wired authentication
ports as static multicast ports. However, MSS can dynamically add these
port types to the list of multicast ports based on multicast traffic.
Examples — The following example changes the multicast router
solicitation interval to 60 seconds:
WX1200# set igmp mrsol mrsi 60
success: change accepted.
See Also
„
set igmp mrsol on page 576.
set igmp oqi Changes the IGMP other-querier-present interval timer on one VLAN or
all VLANs on a WX.
Syntax — set igmp oqi seconds [vlan vlan-id]
„ oqi seconds
— Number of seconds that the WX waits for a general
query to arrive before electing itself the querier. You can specify a
value from 1 through 65,535.
„ vlan vlan-id
— VLAN name or number. If you do not specify a
VLAN, the timer change applies to all VLANs.
Defaults — The default other-querier-present interval is 255 seconds
(4.25 minutes).
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — A WX cannot become the querier unless the pseudo-querier
feature is enabled on the WX switch. When the feature is enabled, the
WX becomes the querier for a subnet so long as the WX does not receive
a query message from a router with a lower IP address than the IP address
of the WX in that subnet. To enable the pseudo-querier feature, use set
igmp querier.
Examples — The following command changes the other-querier-present
interval on VLAN orange to 200 seconds:
WX1200# set igmp oqi 200 vlan orange
success: change accepted.