3Com WXR100 3CRWXR10095A - Manual (Page 556)

556 C HAPTER 12: STP C OMMANDS
set spantree
portvlancost Changes the cost of a network port or ports on paths to the STP root
bridge for a specific VLAN on a wireless LAN switch.
Syntax — set spantree portvlancost port-list cost cost {all |
vlan vlan-id}
„ port-list
— List of ports. MSS applies the cost change to all the
specified ports.
„ cost cost
— Numeric value. You can specify a value from 1 through
65,535. STP selects lower-cost paths over higher-cost paths.
„ all — Changes the cost on all VLANs.
„ vlan vlan-id
— VLAN name or number. MSS changes the cost on
only the specified VLAN.
Defaults — The default port cost depends on the port speed and link
type. (See Table 75 on page 531.)
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — The following command changes the cost on ports 3 and 4
to 20 in VLAN mauve:
WX1200# set spantree portvlancost 3,4 cost 20 vlan mauve
success: change accepted.
See Also
„
clear spantree portcost on page 532
„
clear spantree portvlancost on page 533
„
display spantree on page 536
„
display spantree portvlancost on page 542
„
set spantree portcost on page 553