3Com WXR100 3CRWXR10095A - Manual (Page 123)

display port counters 123
Examples — The following command clears port 5:
WX1200# clear port type 5
This may disrupt currently authenticated users.
Are you sure? (y/n) [n]y
success: change accepted.
See Also
„
set port type ap on page 145
„
set port type wired-auth on page 148
display port
counters Displays port statistics.
Syntax — display port counters
[octets | packets | receive-errors | transmit-errors |
collisions | receive-etherstats |
transmit-etherstats ] [port port-list]
„ octets
— Shows octet statistics.
„ packets — Shows packet statistics.
„ receive-errors
— Shows errors in received packets.
„ transmit-errors
— Shows errors in transmitted packets.
„ collisions — Shows collision statistics.
Table 11 Network port defaults
Port Parameter Setting
VLAN membership None.
Note: Although the command changes a port to a
network port, the command does not place the port
in any VLAN. To use the port in a VLAN, you must
add the port to the VLAN.
Spanning Tree Protocol (STP) Based on the VLAN(s) you add the port to.
802.1X No authorization.
Port groups None.
Internet Group Management
Protocol (IGMP) snooping Enabled as port is added to VLANs.
Access point and radio
parameters Not applicable
Maximum user sessions Not applicable