3Com WXR100 3CRWXR10095A - Manual (Page 113)

set system idle-timeout 113
set system
idle-timeout Specifies the maximum number of seconds a CLI management session
with the switch can remain idle before MSS terminates the session.
Syntax — set system idle-timeout seconds
„ seconds — Number of seconds a CLI management session can remain
idle before MSS terminates the session. You can specify from 0 to
86400 seconds (one day). If you specify 0, the idle timeout is disabled.
The timeout interval is in 30-second increments. For example, the
interval can be 0, or 30 seconds, or 60 seconds, or 90 seconds, and so
on. If you enter an interval that is not divisible by 30, the CLI rounds
up to the next 30-second increment. For example, if you enter 31, the
CLI rounds up to 60.
Defaults — 3600 seconds (one hour).
Access — Enabled.
History — Introduced in MSS Version 4.1.
Usage — This command applies to all types of CLI management sessions:
console, Telnet, and SSH. The timeout change applies to existing sessions
only, not to new sessions.
Examples — The following command sets the idle timeout to 1800
seconds (one half hour):
WX1200# set system idle-timeout 1800
success: change accepted.
See Also
„
clear system on page 92
„
display system on page 95