3Com WXR100 3CRWXR10095A - Manual (Page 493)

set service-profile dhcp-restrict 493
WX4400# set service-profile sp1 cos 7
success: change accepted.
See Also
„
display service-profile on page 401
„
set service-profile static-cos on page 515
set service-profile
dhcp-restrict Enables or disables DHCP Restrict on a service profile. DHCP Restrict filters
the traffic from a newly associated client and allows DHCP traffic only,
until the client has been authenticated and authorized. All other traffic is
captured by the WX and is not forwarded. After the client is successfully
authorized, the traffic restriction is removed.
Syntax
— set service-profile name dhcp-restrict {enable |
disable }
„ name — Service profile name.
„ enable
— Enables DHCP Restrict.
„ disable — Disables DHCP Restrict.
Examples — DHCP Restrict is disabled by default.
Access — Enabled.
History —Introduced in MSS Version 4.2.
Usage — To further reduce the overhead of DHCP traffic, use the set
service-profile no-broadcast command to disable DHCP broadcast
traffic from MAP radios to clients on the service profile’s SSID.
Examples — The following command enables DHCP Restrict on service
profile sp1:
WX4400# set service-profile sp1 dhcp-restrict enable
success: change accepted.
See Also
„
display service-profile on page 401
„
set service-profile no-broadcast on page 499
„
set service-profile proxy-arp on page 500