3Com WXR100 3CRWXR10095A - Manual (Page 580)

580 C HAPTER 13: IGMP S NOOPING C OMMANDS
set igmp qri Changes the IGMP query response interval timer on one VLAN or all
VLANs on a WX.
Syntax — set igmp qri tenth-seconds [vlan vlan-id]
„ qri tenth-seconds — Amount of time (in tenths of a second) that
the WX waits for a receiver to respond to a group-specific query
message before removing the receiver from the receiver list for the
group. You can specify a value from 1 through 65,535.
„ vlan vlan-id — VLAN name or number. If you do not specify a
VLAN, the timer change applies to all VLANs.
Defaults — The default query response interval is 100 tenths of a second
(10 seconds).
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — The query response interval is applicable only when the WX is
querier for the subnet. For the WX to become the querier, the
pseudo-querier feature must be enabled on the WX and the WX must
have the lowest IP address among all the WX switches eligible to become
a querier. To enable the pseudo-querier feature, use set igmp querier.
Examples — The following command changes the query response
interval on VLAN orange to 50 tenths of a second (5 seconds):
WX1200# set igmp qri 50 vlan orange
success: change accepted.
See Also
„
set igmp lmqi on page 574
„
set igmp oqi on page 577
„
set igmp qi on page 579
„
set igmp querier on page 581
„
set igmp rv on page 582