3Com WXR100 3CRWXR10095A - Manual (Page 30)

30 N EW F EATURES S UMMARY
„
display ap config Enhancements on page 54
„
display load Enhancements on page 55
„ display radio-profile Enhancements on page 58
„
display sessions network ap Enhancements on page 60
„
clear sessions network Enhancements on page 61
„
display service-profile Enhancements on page 61
„ display rfdetect Changes on page 66
For more detailed application and usage information on the commands
described in this section, consult the Wireless LAN Switch and Controller
Configuration Guide.
Virtual Controller
Clustering
Configuration New commands support configuration of virtual controller clustering on a
mobility domain.
set cluster mode Enable virtual controller cluster configuration on WXs in a mobility
domain.
Syntax — set cluster mode {enable | disable} preempt {enable
| disable}
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 7.0.
Usage — You must enable cluster mode on all WXs that are members of
the cluster.
Examples — The following command enables cluster mode on a WX in a
mobility domain:
WX# set cluster mode enable
success:change accepted
set cluster preempt Use this command on the secondary seed of the cluster to allow the
secondary seed to become active if the primary seed fails.