3Com WXR100 3CRWXR10095A - Manual (Page 366)

366 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
See Also
„
display ap connection on page 391
„
display ap global on page 393
„
display ap unconfigured on page 395
„
display radio-profile on page 398
„
set ap on page 135
„
set port type ap on page 145
„
set ap bias on page 415
„
set ap group on page 427
„
set ap name on page 429
„
set ap upgrade-firmware on page 444
profile Radio profile that manages the radio. Until you assign the
radio to a radio profile, MSS assigns the radio to the default
radio profile.
auto-tune max-power Maximum power level the RF Auto-Tuning feature can set
on the radio.
„
The value default means RF Auto-Tuning can set the
power up to the maximum level allowed for the country
of operation.
„
A specific numeric value means you or another
administrator set the maximum value.
load-balance-group Names of the RF load-balancing groups to which the MAP
access point belongs. If the value is None, the access point
does not belong to any load balancing groups.
Note: This field is displayed only if the MAP is a member of
a group.
load-balance-enable Whether RF load balancing is enabled for this MAP.
force-rebalance Whether the MAP radio to disassociates its client sessions
and rebalance them whenever a new MAP radio is added to
the RF load balancing group.
local-switching Whether local packet switching is enabled for the
MAP.
vlan-profile The VLAN profile the MAP uses for local packet switching,
indicating which VLANs are locally switched.
Table 54 Output for display ap config (continued)
Field Description