3Com WXR100 3CRWXR10095A - Manual (Page 122)

122 C HAPTER 4: P ORT C OMMANDS
History — Introduced in MSS Version 3.0.
Usage — This command applies only to the WX4400. This command
does not affect a link that is already active on the port.
Examples — The following command clears the preference set on port 2
on a WX4400 switch:
WX4400# clear port preference 2
See Also
„
display port status on page 127
clear port type Removes all configuration settings from a port and resets the port as a
network port.
CAUTION: When you clear a port, MSS ends user sessions that are using
the port.
Syntax —
clear port type port-list
„ port-list
— List of physical ports. MSS resets and removes the
configuration from all the specified ports.
Defaults — The cleared port becomes a network port but is not placed
in any VLANs.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — Use this command to change a port back to a network port. All
configuration settings specific to the port type are removed. For example,
if you clear a MAP access point port, all MAP-specific settings are
removed. Table 11 lists the default network port settings that MSS applies
when you clear a port’s type.