3Com WXR100 3CRWXR10095A - Manual (Page 98)

98 C HAPTER 3: S YSTEM S ERVICE C OMMANDS
See Also
„
clear system on page 92
„
set system contact on page 108
„
set system countrycode on page 109
„
set system idle-timeout on page 113
„
set system location on page 115
„
set system name on page 116
help Displays a list of commands that can be used to configure and monitor
the WX switch.
Syntax — help
Defaults — None.
Access — All.
History — Introduced in MSS Version 3.0.
Examples — Use this command to see a list of available commands. If
you have restricted access, you see fewer commands than if you have
enabled access. To show a list of CLI commands available at the enabled
access level, type the following command at the enabled access level:
WX4400# help
Commands:
-------------------------------------------------------------------------
clear Clear, use 'clear help' for more information
commit Commit the content of the ACL table
copy Copy from filename (or url) to filename (or url)
Memory Current size (in megabytes) of nonvolatile memory
(NVRAM) and synchronous dynamic RAM (SDRAM), plus
the percentage of total memory space in use, in the
following format:
NVRAM size /SDRAM size (percent of total)
Total Power Over
Ethernet Total power that the device is currently supplying to its
directly connected MAP access points, in watts.
Table 8 display system output (continued)
Field Description