3Com WXR100 3CRWXR10095A - Manual (Page 241)

set snmp notify target 241
„ username — USM username. This option is applicable only when the
SNMP version is usm. If the user will send informs rather than traps,
you also must specify the snmp-engine-id of the target.
„ snmp-engine-id
— SNMP engine ID of the target. Specify ip if the
{ip | hex hex-string}
target SNMP engine ID is based on its
IP address. If the target’s SNMP engine ID is a
hexadecimal value, use hex hex-string to
specify the value.
„ profile profile-name
— Notification profile that this SNMP user
will use to specify the notification types to send or drop.
„ security
— Specifies the security level, and is applicable only
{unsecured | when the SNMP version is usm:
authenticated |
-
unsecured
— Message exchanges are not
encrypted} authenticated, nor are they encrypted. This is
the default.
-
authenticated — Message exchanges are
authenticated, but are not encrypted.
-
encrypted — Message exchanges are
authenticated and encrypted.
„ retries num
— Specifies the number of times the MSS SNMP engine
will resend a notification that has not been acknowledged by the
target. You can specify from 0 to 3 retries.
„ timeout num — Specifies the number of seconds MSS waits for
acknowledgement of a notification. You can specify from 1 to 5 seconds.
SNMPv3 with Traps To configure a notification target for traps from SNMPv3, use the
following command:
Syntax —
set snmp notify target target-num ip-addr[:udp-port-number]
usm trap user username
[profile profile-name]
[security {unsecured | authenticated | encrypted}]
„ target-num
— ID for the target. This ID is local to the WX switch and
does not need to correspond to a value on the target itself. You can
specify a number from 1 to 10.
„ ip-addr [ :udp-port-number ] — IP address of the server. You also can
specify the UDP port number to send notifications to.