3Com WXR100 3CRWXR10095A - Manual (Page 767)

set log mark 767
set log mark Configures MSS to generate mark messages at regular intervals. The
mark messages indicate the current system time and date. 3Com can use
the mark messages to determine the approximate time when a system
restart or other event causing a system outage occurred.
Syntax — set log mark [enable | disable] [severity level]
[interval interval]
„ enable — Enables the mark messages.
„ disable — Disables the mark messages.
„ severity level
— Log severity at which the messages are logged:
„
emergency
„
alert
„
critical
„
error
„
warning
„
notice
„
info
„
debug
„ interval interval — Interval at which MSS generates the mark
messages. You can specify from 1 to 2147483647 seconds.
Defaults — Mark messages are disabled by default. When they are
enabled, MSS generates a message at the notice level once every 300
seconds by default.
Access — Enabled.
History — Introduced in MSS Version 4.1.
Examples — The following command enables mark messages:
WX1200# set log mark enable
success: change accepted.
See Also
„
display log config on page 762