3Com WXR100 3CRWXR10095A - Manual (Page 540)

540 C HAPTER 12: STP C OMMANDS
Examples — The following example shows the command output on a
WX switch with backbone fast convergence enabled:
WX4400# display spantree backbonefast
Backbonefast is enabled
See Also
„
set spantree backbonefast on page 550
display spantree
blockedports Lists information about wireless LAN switch ports that STP has blocked on
one or all of its VLANs.
Syntax — display spantree blockedports [vlan vlan-id]
„ vlan vlan-id
— VLAN name or number. If you do not specify a VLAN,
MSS displays information for blocked ports on all VLANs.
Defaults — None.
Access — All.
History —Introduced in MSS Version 3.0.
Usage — The command lists information separately for each VLAN.
Examples — The following command shows information about blocked
ports on a WX switch for the default VLAN (VLAN 1):
WX4400# display spantree blockedports vlan default
Port Vlan Port-State Cost Prio Portfast
------------------------------------------------------------------------
2 190 Blocking 4 128 Disabled
Number of blocked ports (segments) in VLAN 1 : 1
The port information is the same as the information displayed by the
display spantree command. See Table 76 on page 537.
See Also
„
display spantree on page 536