3Com WXR100 3CRWXR10095A - Manual (Page 778)

778 C HAPTER 24: B OOT P ROMPT C OMMANDS
Access — Boot prompt.
History —Introduced in MSS Version 3.0.
Usage — To display the system image software versions, use the fver
command. This command does not list the boot code versions. To display
the boot code versions, use the version command.
Examples — The following command displays all the boot code and
system image files on a WX switch:
boot> dir
Internal Compact Flash Directory (Primary):
WXA30001.Rel 8863722 bytes
Internal Compact Flash Directory (Secondary):
WXA30001.Rel 8862885 bytes
See Also
„
fver on page 780
„
version on page 786
display Displays the currently active boot profile. A boot profile is a set of
parameters that a WX switch uses to control the boot process. Each boot
profile contains the following parameters:
„
Boot type — Either compact flash (local device on the WX switch) or
network (TFTP)
„
Boot device — Location of the system image file
„
Filename — System image file
„
Flags — Number representing the bit settings of boot flags to pass to
the booted system image.
„
Options — String up to 128 bytes of boot options to pass to the
booted system image