3Com WXR100 3CRWXR10095A - Manual (Page 242)

242 C HAPTER 7: IP S ERVICES C OMMANDS
„ username — USM username. This option is applicable only when the
SNMP version is usm.
„ profile profile-name — Notification profile this SNMP user will use
to specify the notification types to send or drop.
„ security
— Specifies the security level, and is applicable only
{unsecured | when the SNMP version is usm:
authenticated |
-
unsecured
— Message exchanges are not
encrypted} authenticated, nor are they encrypted. This is
the default.
-
authenticated — Message exchanges are
authenticated, but are not encrypted.
-
encrypted — Message exchanges are
authenticated and encrypted.
SNMPv2c with
Informs
To configure a notification target for informs from SNMPv2c, use the
following command:
Syntax —
set snmp notify target target-num ip-addr[:udp-port-number]
v2c community-string inform
[profile profile-name]
[retries num]
[timeout num]
„ target-num
— ID for the target. This ID is local to the WX switch and
does not need to correspond to a value on the target itself. You can
specify a number from 1 to 10.
„ ip-addr[:udp-port-number]
— IP address of the server. You also
can specify the UDP port number to send notifications to.
„ community-string — Community string.
„ profile profile-name
— Notification profile this SNMP user will use
to specify the notification types to send or drop.
„ retries num
— Notification profile this SNMP user will use to specify
the notification types to send or drop.
„ timeout num — Specifies the number of seconds MSS waits for
acknowledgement of a notification. You can specify from 1 to 5
seconds.