3Com WXR100 3CRWXR10095A - Manual (Page 557)

set spantree portvlanpri 557
set spantree
portvlanpri Changes the priority of a network port or ports for selection as part of
the path to the STP root bridge, on one VLAN or all VLANs.
Syntax — set spantree portvlanpri
port-list priority value {all | vlan vlan-id}
„ port-list
— List of ports. MSS changes the priority on the specified
ports.
„ priority value
— Priority value. You can specify a value from 0
(highest priority) through 255 (lowest priority).
„ all — Changes the priority on all VLANs.
„ vlan vlan-id
— VLAN name or number. MSS changes the priority on
only the specified VLAN.
Defaults — The default STP priority for all network ports is 128.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — The following command sets the priority of ports 3 and 4 to
48 on VLAN mauve:
WX1200# set spantree portvlanpri 3-4 priority 48 vlan mauve
success: change accepted.
See Also
„
clear spantree portpri on page 533
„
clear spantree portvlanpri on page 534
„
display spantree on page 536
„
set spantree portpri on page 555