3Com WXR100 3CRWXR10095A - Manual (Page 765)

set log 765
„
Logging state (enabled or disabled)
To override the session defaults for an individual session, type the set
log command from within the session and use the current option.
„ trace — Sets log parameters for trace files.
„ Port port-number
— Sets the TCP port for sending messages to the
syslog server. You can specify a number from 1 to 65535. The default
syslog port is 514.
„ severity severity-level — Logs events at a severity level greater
than or equal to the level specified. Specify one of the following:
„ emergency
— The WX switch is unusable.
„ alert — Action must be taken immediately.
„ critical — You must resolve the critical conditions. If the
conditions are not resolved, the WX can reboot or shut down.
„ error — The WX is missing data or is unable to form a connection.
„ warning — A possible problem exists.
„ notice
— Events that potentially can cause system problems have
occurred. These are logged for diagnostic purposes. No action is
required.
„ info
— Informational messages only. No problem exists.
„ debug — Output from debugging.
„ local-facility facility-level — For messages sent to a syslog
server, maps all messages of the severity you specify to one of the
standard local log facilities defined in RFC 3164. You can specify one
of the following values:
„ 0 — maps all messages to local0.
„ 1
— maps all messages to local1.
„ 2
— maps all messages to local2.
„ 3 — maps all messages to local3.
„ 4 — maps all messages to local4.
„ 5
— maps all messages to local5.
„ 6 — maps all messages to local6.
„ 7 — maps all messages to local7.