3Com WXR100 3CRWXR10095A - Manual (Page 231)

set ntp 231
See Also
„
clear ip telnet on page 189
„
display ip https on page 203
„
display ip telnet on page 206
„
set ip https server on page 225
„
set ip telnet on page 229
set ntp Enables or disables the NTP client on a WX.
Syntax — set ntp {enable | disable}
„ enable
— Enables the NTP client.
„ disable — Disables the NTP client.
Defaults — The NTP client is disabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — If NTP is configured on a system whose current time differs
from the NTP server time by more than 10 minutes, convergence of the
WX time can take many NTP update intervals. 3Com recommends that
you set the time manually to the NTP server time before enabling NTP to
avoid a significant delay in convergence.
Examples — The following command enables the NTP client:
WX4400# set ntp enable
success: NTP Client enabled
See Also
„
clear ntp server on page 189
„
clear ntp update-interval on page 190
„
display ntp on page 207
„
set ntp server on page 232
„
set ntp update-interval on page 233